IVECO Eurocargo 4x4: slide-on camper payload

IVECO Eurocargo 4x4 has a recorded GVM of 15,000 kg. Chassis-cab mass is 5,538 kg to 5,570 kg; payload calculated as GVM minus that mass is 9,430 kg to 9,462 kg across 2 recorded variants. After a stated 390 kg allowance for occupants, accessories and gear, the remaining body and camper load allowance is 9,040 kg to 9,072 kg. [1]

What the allowance assumes

We subtract 160 kg for occupants, 150 kg for accessories and 80 kg for luggage and gear: 390 kg total. These are assumptions, not measured weights. Published mass bases differ; some already include a driver or fuel. Avoid counting those twice when entering your actual weights.

This is remaining mass allowance, not an approved camper dry weight. Allow for any excluded tray or body, mounting frame, water and camper equipment. No camper fitment verdict is available without verified camper mass, dimensions and centre of gravity.

Change the assumptions in the weight calculator. Enter your occupant, accessory and gear weights there; these assumptions are not automatically filled.

Recorded variants, highest calculated payload first

Model years: 2024. Match your exact variant and mass basis. “Verified” describes the research record, not approval for a camper.

All figures in kilograms unless stated. Sources and review status apply to each row.
Variant / yearGVM / GCMChassis-cab massPayload / allowanceTray / axle limitsSource and caveats
ML150E32W 4x4 Cab Chassis 3915mm wheelbase2024 · day cab · 4x4Calculate ML150E32W 4x4 Cab Chassis 3915mm wheelbase 202415,000 kgGCM: 19,000 kg5,538 kgIVECO indicative weight with standard options, 180 litres of fuel, 30 litres of AdBlue and driver. Plus or minus 3 percent tolerance appliesFront: 3,697 kg
Rear: 1,841 kg		Calculated: 9,462 kgPublished body payload: Not publishedAfter 390 kg: 9,072 kgArithmetic: cannot cross-checkTray inclusion unknown: confirm actual tray/body mass before using the allowance.Front axle limit: 5,700 kg
Rear axle limit: 10,000 kgRear axle headroom before body and loads: 8,159 kgBolted and riveted parallel channel chassis, 420 MPa yield. Obtain the IVECO body-builder directive and confirm frame loading before body design or mounting.		[1] Eurocargo 4x4 ML150E32W Specification SheetSpecification sheet, "DIMENSIONS & WEIGHTS" table, 3915 mm wheelbase column; axle and suspension capacities from the chassis table on the same sheet.source verifiedUnlike the T-Way sheets in the same range, this kerb basis already includes 180 litres of fuel, 30 litres of AdBlue and a driver, so it is the conservative figure rather than the flattering one, and the payload derived from it is closer to what the vehicle will really carry. Plus or minus 3 percent is still plus or minus 166 kg. Overall length 6,666 mm, rear overhang 1,358 mm, unladen frame height 1,228 mm, day cab. Maximum body length is not published; the sheet gives front-axle-to-back-of-cab as 385 mm including the filter, and that is not derived here.Official IVECO Australia specification sheet, read directly. Publishes total kerbweight with a front/rear split for both wheelbases, plated GVM and GCM, and axle and suspension capacities. Its kerb basis INCLUDES 180 litres of fuel, 30 litres of AdBlue and a driver, which is heavier and more conservative than the T-Way sheets in the same range, which exclude all three. Document footer dated 01/26; the MY24 designation comes from the product line the sheet sits under.
ML150E32W 4x4 Cab Chassis 4150mm wheelbase2024 · day cab · 4x4Calculate ML150E32W 4x4 Cab Chassis 4150mm wheelbase 202415,000 kgGCM: 19,000 kg5,570 kgIVECO indicative weight with standard options, 180 litres of fuel, 30 litres of AdBlue and driver. Plus or minus 3 percent tolerance appliesFront: 3,698 kg
Rear: 1,872 kg		Calculated: 9,430 kgPublished body payload: Not publishedAfter 390 kg: 9,040 kgArithmetic: cannot cross-checkTray inclusion unknown: confirm actual tray/body mass before using the allowance.Front axle limit: 5,700 kg
Rear axle limit: 10,000 kgRear axle headroom before body and loads: 8,128 kgBolted and riveted parallel channel chassis, 420 MPa yield. Obtain the IVECO body-builder directive and confirm frame loading before body design or mounting.		[1] Eurocargo 4x4 ML150E32W Specification SheetSpecification sheet, "DIMENSIONS & WEIGHTS" table, 4150 mm wheelbase column; axle and suspension capacities from the chassis table on the same sheet.source verifiedUnlike the T-Way sheets in the same range, this kerb basis already includes 180 litres of fuel, 30 litres of AdBlue and a driver, so it is the conservative figure rather than the flattering one, and the payload derived from it is closer to what the vehicle will really carry. Plus or minus 3 percent is still plus or minus 167 kg. Overall length 7,478 mm, rear overhang 1,935 mm, unladen frame height 1,238 mm, day cab. Maximum body length is not published; the sheet gives front-axle-to-back-of-cab as 385 mm including the filter, and that is not derived here.Official IVECO Australia specification sheet, read directly. Publishes total kerbweight with a front/rear split for both wheelbases, plated GVM and GCM, and axle and suspension capacities. Its kerb basis INCLUDES 180 litres of fuel, 30 litres of AdBlue and a driver, which is heavier and more conservative than the T-Way sheets in the same range, which exclude all three. Document footer dated 01/26; the MY24 designation comes from the product line the sheet sits under.

Rear axle headroom is the published limit minus the recorded chassis-cab rear mass, where both exist. The body, subframe and loaded camper consume this margin; front axle, tyres and load distribution still need checking.

GVM upgrade arithmetic

If GCM stays unchanged, each extra kilogram of loaded vehicle mass leaves one kilogram less under GCM for a trailer. The IVECO Eurocargo 4x4 table uses published GCM minus hypothetical GVM; it does not certify an upgrade or override the published towing limit. No certified upgrade figures are recorded. The increments below are illustrative scenarios, not available or approved upgrades. They assume the vehicle is loaded to the stated hypothetical GVM and GCM stays unchanged.

Combination-mass allowance for a trailer at full GVM, before towing and other limits
VariantPublished GCMAt stock GVMGVM +500 kgGVM +1000 kgGVM +1500 kgPublished braked towing limit
ML150E32W 4x4 Cab Chassis 3915mm wheelbase · 2024 · day cab · 4x4Variant and source [1]19,000 kg4,000 kgGVM 15,000 kg3,500 kgHypothetical GVM 15,500 kg3,000 kgHypothetical GVM 16,000 kg2,500 kgHypothetical GVM 16,500 kgNot published
ML150E32W 4x4 Cab Chassis 4150mm wheelbase · 2024 · day cab · 4x4Variant and source [1]19,000 kg4,000 kgGVM 15,000 kg3,500 kgHypothetical GVM 15,500 kg3,000 kgHypothetical GVM 16,000 kg2,500 kgHypothetical GVM 16,500 kgNot published

A negative result means the hypothetical vehicle mass already exceeds GCM. A positive result is not permission to tow that mass: the manufacturer's towing rating, towbar, towball load, axle limits and actual certification also apply.

Manufacturer sources and currency

These are stored research figures, not a live check of current specifications. Access dates below identify when each source was recorded.

  1. Eurocargo 4x4 ML150E32W Specification Sheet — IVECO Trucks Australia. Accessed 2026-09-05.

    Official IVECO Australia specification sheet, read directly. Publishes total kerbweight with a front/rear split for both wheelbases, plated GVM and GCM, and axle and suspension capacities. Its kerb basis INCLUDES 180 litres of fuel, 30 litres of AdBlue and a driver, which is heavier and more conservative than the T-Way sheets in the same range, which exclude all three. Document footer dated 01/26; the MY24 designation comes from the product line the sheet sits under.

IVECO Eurocargo 4x4 payload questions

What is the payload of a IVECO Eurocargo 4x4?

IVECO Eurocargo 4x4 has a recorded GVM of 15,000 kg. Chassis-cab mass is 5,538 kg to 5,570 kg; payload calculated as GVM minus that mass is 9,430 kg to 9,462 kg across 2 recorded variants. After a stated 390 kg allowance for occupants, accessories and gear, the remaining body and camper load allowance is 9,040 kg to 9,072 kg.

How much can a IVECO Eurocargo 4x4 carry with a slide-on camper?

The calculated allowance is 9,040 kg to 9,072 kg after 160 kg for occupants, 150 kg for accessories and 80 kg for gear. Any tray or body excluded from the recorded mass, camper water and camper equipment still have to be allowed for. This is not a camper fitment verdict.

Does a GVM upgrade reduce a IVECO Eurocargo 4x4's towing capacity?

If GCM stays unchanged, each extra kilogram of loaded vehicle mass leaves one kilogram less under GCM for a trailer. The IVECO Eurocargo 4x4 table uses published GCM minus hypothetical GVM; it does not certify an upgrade or override the published towing limit.

Check your actual weights in the calculator

This tool provides an estimate only. Final suitability depends on your exact vehicle variant, compliance plate, manufacturer specifications, towbar rating, axle limits, tyre ratings, accessories, real loaded weights and certified weighbridge results. Beyond RV weighs your vehicle at the factory before build, and those figures decide the final answer.

Other vehicle models